12v Power Supply (33A, 400W)

12v Power Supply (33A, 400W)
Product Code: E-PSU-12V-400W
Availability: In Stock
£32.00

(Excludes VAT for UK/EU customers)

Qty: Add to Cart

Power supply for RepRap 3D Printers. 

 
  
  
 
PropertyS-400-12vS-400-24v
DC output voltage12v24v
DC output current33A16.5A
DC output voltage error±1%±1%
Ripple and noise150mV150mV
Efficiency74%81%
Input current6.5A/115V 4A/230V6.5A/115V 4A/230V
AC input voltage range85-132VAC/170-264vac 47-63HZ 240-370VDC85-132VAC/170-264vac 47-63HZ 240-370VDC
Over load protection105-135% cut off the output auto -recovery105-135% cut off the output auto -recovery
Over-voltage protection115-135 cut off the output auto -recovery115-135 cut off the output auto -recovery
Weight1.05kg1.05kg
  
  

IMPORTANT

There is a voltage-selector switch so configure the PSU to match your national supply voltage which must be checked and set upon receipt of the supply. The default setting is 220v which is less likely to cause damage if plugged into a 110v supply, however the reverse may cause irreversible damage. 

Friendly advice

This part is aimed at experienced users, if you are not comfortable wiring in your own mains then please consider an alternative supply. All terminals must be insluated to avoid short-circuit and risk of electrocution to anyone that may be exposed to your printer. Please play safe!

 

There are no reviews for this product.

Write a review

Your Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Also Bought
​Power supply for RepRap 3D Printers.       ..
£32.00

Semitec 100kOhm NTC Thermistor. (104GT-2)Technical Data:For the datasheet, see the ATC ..
£3.50

This is polyimide film tape with a silicone adhesive; also known as Kapton tape. Used for insulating..
£9.00