Ceramic Screwdriver for Adjusting Stepper Drivers

Ceramic Screwdriver for Adjusting Stepper Drivers
Product Code: E-CERAMIC-DRIVER
Availability: In Stock
£2.50

(Excludes VAT for UK/EU customers)

Qty: Add to Cart

These are for adjusting those little current setting potentiometers on stepper drivers. The non-conducting tip means that accidentally poking other components, pins, or traces won't damage or interfere with the stepper driver. Using metal tipped screwdrivers while the driver is powered on can cause damage to the driver or even the controller board. Additionally using a metal tipped driver often introduces electrical noise during the adjustment as the metal driver acts as a small antenna making precise adjustment hard.

These are a good quality Japanese branded driver that should last for your entire 3D printing lifetime. 

Should not be used as a general purpose screwdriver for doing up screws etc, the ceramic tip is not tough or strong enough for applying larger torques.

There are no reviews for this product.

Write a review

Your Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Also Bought
These high-quality pneumatic push-fit couplings have a 1/8"  thread and screw directl..
£1.50

These are for adjusting those little current setting potentiometers on stepper drivers. The non-cond..
£2.50

This is a greatly enhanced PLA based material which outperforms even ABS in mechanical strength and ..
£27.50

ColorFabb XT, 1.75mm is an Amorphous Co-Polyester filament for 3D Printers.This materi..
£25.00
1 reviews