UHU Stic

UHU Stic
Product Code: M-SURFACE-UHU
Availability: In Stock
£2.00

(Excludes VAT for UK/EU customers)

Qty: Add to Cart

This great little find makes PLA and ABS stick like nothing else we've ever used! Better adhesion than blue tape for PLA, and better than ABS juice or Kapton for ABS. The surface is usable multiple times before needing to be applied again, so no constant reapplication of ABS juice, or damaged tape. You can use the same surface for both PLA and ABS, so no need to constantly switch bed types. When the parts cool they release themselves from the bed easily. It has completely replaced all other types of surface for us here at E3D and so we thought we'd offer it here too.

 

Just a very thin layer on the print surface (we use glass) creates a surface that PLA will stick to when cold, or you can increase the temperature to get even more adhesion and combat warp.

 

Again, just a thin layer will create a surface that ABS will stick to when the bed is hot - we use 110C, but people have reported that they can print down to 80C with great adhesion still.

 

The surface is usable multiple times before needing to be applied again, so no constant reapplication of ABS juice, or damaged tape. You can use the same surface for both PLA and ABS, so no need to constantly switch bed types. When the parts cool they release themselves from the bed easily.

on
5 ( 5 / 5 )
Sticks like crazy, sometimes have to use a hammer to get my PLA pieces from the bed (glass with uhu stick @ 50C). Haven't printed with abs yet though.
on
5 ( 5 / 5 )
I use UHU glue sticks, and apart from making sure I have an even layer before heating the bed I have no problems. The best solution I have founds so far ! so easy to use.
on
5 ( 5 / 5 )
Using UHU Glue Stic with ABS/PLA will cause your prints to literally"Stick Like S***"I have used a few methods but this glue is AWESOME!
on
5 ( 5 / 5 )
I am in a position to document my view and observations about UHU glue stick in a very few words.Apply a thin layer when the bed is at about 50'c and prints Stick Like S***! so well in fact, its best to wait for the bed too cool rather than risk damage. If you get any lifting then you have been too conservative about the layer or the time left on the heated bed before print started.Enjoy

Write a review

Your Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Also Bought
This great little find makes PLA and ABS stick like nothing else we've ever used! Better adhesion th..
£2.00
4 reviews

PTFE Heat Shrink for insulating cabling at high temperatures.We will try to fulfil your order in..
£3.00