
Please find post Brexit import information here, make sure to check your charges and if they don't match up then please get in contact with us before paying them. Continue to buy with confidence and be assured that we have implemented a plan which aims to ensure the least disruptive and cost-effective solution for our customers, your patience during this time is much appreciated.
PT100 temperature sensor
Allow your HotEnd to print at higher temperatures with better accuracy and easier assembly with a PT100 sensor.
Please note:
In most cases, an amplifier board will be required, along with a spare 5v, GND, and a signal pin.
Key features:
- Max temperature: 500°C
- Cartridge diameter: 3mm
- Cartridge length: 15mm
- Cable length: 50mm
- Cable colour: red
- Cable connector: Molex microfit 3.0
Kit includes:
- 1 x PT100
- 1 x Extension cable