v6 Heater Block & Fixings (Thermistor Clamping)
£9.00 £10.80
69 available immediately + 4110 available after a short delay

This is a replacement Heater Block designed for E3D V6 and Lite6 Hot Ends, plus a set of fixings for mounting your HotEnd.

This is an old-style thermistor clamping heater block for a v6 hotend. To upgrade to newer sensor cartridge style heater block, check out the block and sock upgrade kit

This product also comes with the following fixings:

  • M3x0.5x4 socket dome screw and washer to clamp thermistor
  • M3x0.5x10 socket dome screw to clamp heater cartridge
  • Note that this product does not come with a thermistor, purchase those separately
Write Your Own Review
Write a review

This Heater block is compatible with the E3D ecosystem of Hot Ends and nozzles. It does NOT fit a Cyclops Hot End or Volcano nozzles.V5 and V6 Heater Blocks are cross compatible as both use an M6 thread. Note that V6 heater blocks are 0.5mm shorter than V5.

See our full documentation here: https://e3d-online.dozuki.com

Copyright © 2017 E3D-Online.com All Rights Reserved Company Number: 8496321 VAT Number: GB171059715