We don't have any specific recommendations for this product at the moment.
The v6 Heater Block has been upgraded to clamp both the heater cartridge and thermistor in place. These design improvements improve the thermal response of the HotEnd and make thermistor assembly easier.
This product also comes with the following fixings:
- M3x0.5x4 socket dome screw and washer to clamp thermistor
- M3x0.5x10 socket dome screw to clamp heater cartridge
- v5 and v6 Heater Blocks are cross compatible, both use an M6 thread. Note that v6 heater blocks are 0.5mm shorter than v5.
- Volcano Block for Sensor CartridgesThis Volcano heater block allows you to use our high tempe...£15.00 £18.00Thermal Compound Paste1g Packet of thermal compound paste£1.00 £1.20Experimental Ceramic Heater Cartridge - 240v - 100wHigh-wattage ceramic Heater Cartridge for DIY heater beds....£15.00 £18.00Experimental Ceramic Heater Cartridge - 110v 100wHigh-wattage ceramic Heater Cartridge for DIY heater beds....£15.00 £18.00100k Ohm NTC Axial Thermistor - HoneywellHoneywell 100kOhm NTC Thermistor in an axial package.£3.50 £4.20100k Ohm NTC Thermistor - SemitecSemitec 100kOhm NTC Thermistor for all your temperature-se...£3.50 £4.20Fibreglass Sleeving for Insulating Thermistors (100mm)Fibreglass sleeving is used in HotEnds for easy, neat, and...£0.25 £0.30Cyclops/Cyclops+ Heat BreakThis is a replacement heat break for the E3D Cyclops Hot E...£12.00 £14.40PT100 Temperature SensorMake your HotEnd run at higher temperatures with better ac...£12.50 £15.00V6 Heater Block for Sensor CartridgesThis heater block works with our new standard thermistor t...£11.50 £13.80
Copyright © 2017 E3D-Online.com All Rights Reserved Company Number: 8496321 VAT Number: GB171059715