Volcano Block for Sensor Cartridges
£15.00 £18.00
321 available immediately + 306 available after a short delay
This Volcano heater block allows you to use our high temperature, high accuracy PT100 temperature sensors on your E3D Volcano, making it intercompatible with the PT100 Upgrade Kit on your E3D V6 HotEnd.

This Volcano heater block allows you to use our new thermistor cartridges, as well as a high temperature, high accuracy PT100 temperature sensors.

These are the newer version of the Volcano heater block, and are equivalent to what is comes in an eruption or power pack kit. With this heater block you can use the supplied M3 grub screw to quickly and easily secure or release your temperature sensor.

The heater block also comes with spare M3 Socket Screws to clamp the heater cartridge. This kit does not include either electronic component, however.

To upgrade your Volcano to PT100, go here :)

Write Your Own Review
Write a review

This Heater block is compatible with the E3D ecosystem of Hot Ends and Volcano nozzles. It does NOT fit a Cyclops Hot End. V5 and V6 Heater Blocks are cross compatible as both use an M6 thread. Note that V6 heater blocks are 0.5mm shorter than V5.

See our full documentation here: https://e3d-online.dozuki.com

Copyright © 2017 E3D-Online.com All Rights Reserved Company Number: 8496321 VAT Number: GB171059715