This precision milled POM mounting plate is useful for printers that have 50mm spaced holes below the extruder. Fits tightly around the E3D-v6 hotend groovemount and allows you to clamp the hotend up to your extruder with 2x screws.
Specs for other maybe buyers-
Ext dimensions- 30.0mm x 70.0mm x 5.5mm
Holes- 4.2mm x 10.1mm // 50.0mm centre to centreThe mount has a smooth, snug fit on the v6 heat sink mounting groove side to side where it is gripped by the plate on either side though the heat sink has front to back movement from the 0.5mm vertical tolerance and/or the lack of front to back compression. This twist translates to quite a bit of motion on the hot end tip. If it was made from 6mm thick material (or the heat sink was 5.5mm high) this would the the perfect mount. I bought two and both where identical.
Alex on 27/11/2014
( 3 / 5 )
Mechanical drawings for this hardware would be great please!