v6 Heater Block & Fixings (Thermistor Clamping)

v6 Heater Block & Fixings (Thermistor Clamping)
Product Code: V6-BLOCK-THERM-ALU
Availability: In Stock
£9.00

(Excludes VAT for UK/EU customers)

Qty: Add to Cart

The v6 Heater Block has been upgraded to clamp both the heater cartridge and thermistor in place. These design improvements improve the thermal response of the HotEnd and make thermistor assembly easier.

This product also comes with the following fixings:

  • M3x0.5x4 socket dome screw and washer to clamp thermistor
  • M3x0.5x10 socket dome screw to clamp heater cartridge

Compatibility

  • v5 and v6 Heater Blocks are cross compatible, both use an M6 thread. Note that v6 heater blocks are 0.5mm shorter than v5. 

Engineering Drawings

on
3 ( 3 / 5 )
Beware!! the items shown in the image are NOT what you will get. It is only the heater block! Along with some screws and washers (and, of course, the gummy starmix :)). I'm very happy with E3D products, the V6 is a fantastic extruder but the image is deceiving although I don't think it's intentional

Write a review

Your Name:


Your Review:Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Also Bought
These are for adjusting those little current setting potentiometers on stepper drivers. The non-cond..
£2.50

The v6 Heater Block has been upgraded to clamp both the heater cartridge and thermistor in place. Th..
£9.00
1 reviews

E3D-v6: Smaller - Easier - Higher Performance.From mid-June 2016 E3D Hotends will transitio..
£47.00
6 reviews