E3D Help Centre

Revo Support: Revo Six

Table of Contents

Summary

  • Mass: ~53g
  • Fan Voltage: 12V or 24V
  • Filament Diameter: 1.75mm
  • Drop-in upgrade for Prusa MK2 and MK3 Variants

Operational Temperatures

  • Maximum recommended ambient operating temperature (PLA): 40°C
  • Lowest temperature rated component: Fan 70°C

Electrical Specification

  • Fan:
    • Voltage: 12V or 24V
    • Current: 0.1A (12V) or 0.08A (24V)

Materials

  • Heatsink: Auminium (Black andodised)
  • Fan Shroud: Polycarbonate

Volumes & Dimensions

Mounting Dimensions

Upgrade Guides

Assembly Guides

A. 1x Collet F. 4x Self-tapping screws J. 1x Thermistor extension cable
B. 1x Collet Clip G. 1x Spring K. 1x Fan extension cable
C. 1x HeatSink H. 1x HeaterCore L. 1x Heater extension cable
D. 1x Fan Duct I. 1x Revo Nozzle
E. 1x 3010 Fan

 

Spring attachment

  • Attach the spring to the groove on the bottom of the Heatsink.

Heater core assembly

  • Attach the HeaterCore to the HeatSink and spring assembly.
  • A slight twisting motion may be required.

Nozzle installation

  • Screw the Nozzle into Heatsink, it should slide freely through the HeaterCore.
  • There is no need to use tools, this step should be done using your hands only. Hot-tightening NOT required.
  • This step should be completed with the HotEnd at 50°C and lower only!

Fan installation

  • Attach the fan and fan duct to the HeatSink.
  • Make sure the fan sticker is facing towards the HeatSink.

Collet installation

  • Insert collet and collet clip into the top of the HeatSink.

3D connectors illustration

  • The colour of the HeaterCore thermistor wire has recently changed from white to blue. If your HeaterCore has a white thermistor cable. Please refer to the diagram below.

Wiring diagram

  • Attach the HotEnd extension cable.

Firmware/ Printer Config

Rep Rap

  • configure the temperature sensor to: Semitec 104-GT2 (used by E3D)
  • Set the maximum temperature to: 300

Marlin 2.0

  • Change: #define TEMP_SENSOR_0 1
  • To: #define TEMP_SENSOR_0 5
  • Change: #define HEATER_0_MAXTEMP 275 (your value may vary)
  • To: #define HEATER_0_MAXTEMP 300
  • Ensure: #define HEATER_0_MINTEMP 5

Klipper

  • See Klipper docs
  • The standard Revo HeaterCore uses the ATC Semitec 104NT-4-R025H42G.

Reference CAD