Revo Diamondback Nozzle
DATASHEET
Warnings
- During use and cooldown, there is a potential to burn your hands.
- Your HotEnd and printer are your responsibility. We cannot be held responsible for damages caused by our products use, misuse or abuse.
- Revo nozzles are to be fastened by hand without the use of tools
- Revo Nozzles must be fastened at room temperature to avoid burn injuries.
Summary
- Compatible with: Revo Hemera XS, Revo Hemera, Revo Micro, Revo Six, Revo Voron, Revo CR, Revo Prusa MK3, Revo Prusa Mini, Revo Micro LGX, Revo Biqu H2V2, Revo Microswiss NG
- Mass: 8g
- Filament diameter: 1.75mm
Volume and Dimensions
Nozzle Identification
| Diameter (mm) | Sock colour | Max temperature °C | Abrasion resistant? | Nozzle Colour |
|---|---|---|---|---|
| 0.25 | Yellow | 300 | Yes | Brass Yellow |
| 0.40 | Red | 300 | Yes | Brass Yellow |
| 0.60 | Blue | 300 | Yes | Brass Yellow |
| 0.80 | Green | 300 | Yes | Brass Yellow |
Exploded View
- Revo Nozzle
- Revo Nozzle sock
Changelog
Edition 8
Approved: , Published: , Notes: HF Nozzles added
Edition 7
Approved: DR 03/03/23, Published: 03/03/23, Notes: Nozzle drawing updated
Edition 6
Approved: DR 04/10/22, Published: 04/10/22, Notes: ObXidian table added
Edition 5
Approved: RY 19/07/22, Published: 19/07/22, Notes: Migrated to Zendesk and added illustration to identification section
Edition 4
Approved: RY 23/03/22, Published: 23/03/22, Notes: Added total length tolerance and removed flow rate
Edition 3
Approved: DR 07/12/21, Published: 07/12/21, Notes: Flow rate units changed to 10mm³/sec
Edition 2
Approved: RY 13/10/21, Published: 12/10/21, Notes: Revo Thread renamed Revo Micro
Edition 1
Approved: RY 17/09/21, Published: 17/09/21
Compliance
