Based on Govt guidance, we are continuing to operate remotely, providing support via email and telephone. Orders are being fulfilled as normal with the exception of out of stock items which understandably have a longer lead time. Please bear in mind that there may be delays with courier services. You can report bugs or provide general feedback on this site here.
Power supply for RepRap 3D Printers.
|DC output voltage||12v||24v|
|DC output current||33A||16.5A|
|DC output voltage error||±1%||±1%|
|Ripple and noise||150mV||150mV|
|Input current||6.5A/115V 4A/230V||6.5A/115V 4A/230V|
|AC input voltage range||85-132VAC/170-264vac 47-63HZ 240-370VDC||85-132VAC/170-264vac 47-63HZ 240-370VDC|
|Over load protection||105-135% cut off the output auto -recovery||105-135% cut off the output auto -recovery|
|Over-voltage protection||115-135 cut off the output auto -recovery||115-135 cut off the output auto -recovery|
There is a voltage-selector switch so configure the PSU to match your national supply voltage which must be checked and set upon receipt of the supply. The default setting is 220v which is less likely to cause damage if plugged into a 110v supply, however the reverse may cause irreversible damage.
This part is aimed at experienced users, if you are not comfortable wiring in your own mains then please consider an alternative supply. All terminals must be insluated to avoid short-circuit and risk of electrocution to anyone that may be exposed to your printer. Please play safe!