We don't have any specific recommendations for this product at the moment.
PT100's are high temperature, high accuracy temperature sensors that you can now use on your E3D V6 HotEnd instead of a thermistor or thermocouple. PT100's are able to measure higher temperatures than thermistors - upto 400°C, and are more accurate then both thermistors and thermocouples in general. Our PT100 sensors are also very easy to handle, being of a metal cartridge type construction that is secured with a set screw, no more fiberglass sleeving or clamping washer.
The PT100 sensor will not fit in the standard E3D Hotends, but can be used with E3D V6, Chimera, Lite6, and Kraken by using the PT100 Heater Block available in the spares and extras section.
Please be aware that a PT100 is not the same as a thermistor and unless your electronics explicitly supports RTD Sensing devices you will need an amplifier board.
The Ultimaker 2 uses PT100 sensors by default, and this sensor allows you to connect your E3D Hotend and Ultimaker electronics with no alteration to the electronics or firmware of the Ultimaker 2.
The PT100 sensor can be used with E3D v6, Chimera, Lite6, and Kraken by using the PT100 Heater Block available in the spares and extras section. Please be aware that a PT100 is not the same as a thermistor and unless your electronics explicitly supports RTD Sensing devices you will need an amplifier board.
- 100k Ohm NTC Axial Thermistor - HoneywellHoneywell 100kOhm NTC Thermistor in an axial package.£3.50 £4.20100k Ohm NTC Thermistor - SemitecSemitec 100kOhm NTC Thermistor for all your temperature-se...£3.50 £4.20Type K Thermocouple (Welded Tip)These thermoucouples can be used in place of your thermist...£10.00 £12.00v6 HotEnd Metal Parts Only - 3.00mm DirectThe E3D V6 Hot End is easier, smaller, and higher performa...£31.00 £37.20Fibreglass Sleeving for Insulating Thermistors (100mm)Fibreglass sleeving is used in HotEnds for easy, neat, and...£0.25 £0.30Ferrules for joining wires (Pack of 10)Handy little crimp ferrules for making easy quick high tem...£1.00 £1.20Fan/Thermistor Molex Connector CableA nice long (1000mm) connector cable, red and black colour...£0.80 £0.96Cyclops Heater Block (old style)A replacement heater block for the E3D Cyclops Hot End.&nb...£40.00 £48.00v6 Heater Block & Fixings (Thermistor Clamping)This is a replacement Heater Block designed for E3D V6 and...£9.00 £10.80Thermistor Replacement KitA kit containing the parts you need to replace a broken ol...£4.00 £4.80Thermal Compound Paste1g Packet of thermal compound paste£1.00 £1.20V6 Stainless Steel Heater Block for Sensor CartridgesStainless steel heater blocks to pair with stainless steel...£20.00 £24.00
Copyright © 2017 E3D-Online.com All Rights Reserved Company Number: 8496321 VAT Number: GB 171 0597 15