Table of Contents
Summary
- Maximum printing temperature: 320°C
- Mass: 30.5g (Assembled)
- Filament diameter: 1.75mm
- Maximum ambient printing temperature: 60°C
- Compatibility: X1 Carbon, X1E, P1S/P1P
Upgrade Guides
Volumetric Flow Rates
| Nozzle Diameter | Filament and Temperature (°C) | Volumetric Flow Rate (mm³/s) |
|---|---|---|
| 0.40 | PLA 220 | 18 |
| PETG 240 | 20 | |
| ASA 260 | 21 | |
| 0.60 | PLA 220 | 21 |
| PETG 240 | 26 | |
| ASA 260 | 24 | |
| 0.80 | PLA 220 | 23 |
| PETG 240 | 31 |
Filter by Filament Type:
Filter by Nozzle Diameter:
Slicer Guidelines
- Always enable flow dynamics when starting a print
- If you are experiencing over or underextrusion we recommend following Bambu's guide on flow rate calibration
- If you are using a non Bambu Filament and not getting the results you were expecting, it's a good idea to run a temperature test calibration.
- If you are experiencing excessive stringing or blobs then we recommend running a retraction test
Cleaning Guidelines
Recommended cleaning methods
- Nylon cleaning filament (internal cleaning method)
- Warm pull (internal cleaning method)
- Cold pull (internal cleaning method)
- Brass brush (external cleaning method)
Non-recommended cleaning methods
- Needle (internal cleaning)
- Steel wire brushes (external cleaning methods)
- Blow torch (internal/external cleaning method)
