E3D Help Centre

Revo Support: High Temperature High Flow Abrasive Nozzles

Contents

Summary

  • Compatible with: Revo Hemera XS, Revo Hemera, Revo Micro, Revo Six, Revo Voron, Revo CR, Revo Prusa MK3, Revo Prusa Mini, Revo Micro LGX, Revo Biqu H2V2, Revo Microswiss NG, BIQU Revo Panda
  • Mass: 8g
  • Filament diameter: 1.75mm

Volumes & Dimensions

Maximum Volumetric Flow Rates

Nozzle Diameter Filament and Temperature (°C) Volumetric Flow Rate (mm³/s)
0.40 PLA 220 16
PETG 240 23
ASA 260 25
0.60 PLA 220 22
PETG 240 28
ASA 260 28
0.80 PLA 220 28
PETG 240 34
ASA 260 33
1.00 PLA 220 35
PETG 240 38
ASA 260 41
1.20 PLA 220 37
PETG 240 42
ASA 260 46
1.40 PLA 220 37
PETG 240 44
ASA 260 46

Nozzle Diameter vs Volumetric Flow Rate

Filter by Filament Type:

Nozzle Identification

Diameter (mm) Sock colour Max temperature °C Abrasion resistant? Nozzle Colour
0.40 N/A 500 Yes Dull Grey
0.60
 N/A 500 Yes Dull Grey
0.80 N/A 500 Yes Dull Grey
1.00 N/A 500 Yes Dull Grey
1.20 N/A 500 Yes Dull Grey
1.40 N/A 500 Yes Dull Grey

Nozzle Cleaning Guidelines

Recommended cleaning methods:

  • Nylon cleaning filament (internal cleaning method)
  • Warm pull (internal cleaning method)
  • Cold pull (internal cleaning method)
  • Brass brush (external cleaning method)

Non-recommended cleaning methods

  • Needle (internal cleaning)
  • Steel wire brushes (external cleaning method)
  • Blow torch (internal/ external cleaning method)

The hardness of the HT-Abrasive coating can cause small particles to detach from the bristles of the brass brush and create dusting over the nozzle. This will give the nozzle a brass-coloured sheen. However, the coating itself is still very much intact, and there will be no compromise to wear performance.

You can use this nozzle to print different materials. Just make sure to purge the filament thoroughly before starting each print with a new material.