Summary
- Compatible with: Revo Hemera XS, Revo Hemera, Revo Micro, Revo Six, Revo Voron, Revo CR, Revo Prusa MK3, Revo Prusa Mini, Revo Micro LGX, Revo Biqu H2V2, Revo Microswiss NG, BIQU Revo Panda
- Mass: 8g
- Filament diameter: 1.75mm
Volumes & Dimensions
Nozzle Identification
| Diameter (mm) | Sock colour | Max temperature °C | Abrasion resistant? | Nozzle Colour |
|---|---|---|---|---|
| 0.40 | Red | 300 | Yes | Iridescent Black |
| 0.60 |
Blue | 300 | Yes | Iridescent Black |
| 0.80 | Green | 300 | Yes | Iridescent Black |
| 1.00 | Black | 300 | Yes | Iridescent Black |
| 1.20 | Purple | 300 | Yes | Iridescent Black |
| 1.40 | Orange | 300 | Yes | Iridescent Black |
Nozzle Cleaning Guidelines
Recommended cleaning methods:
- Nylon cleaning filament (internal cleaning method)
- Warm pull (internal cleaning method)
- Cold pull (internal cleaning method)
- Brass brush (external cleaning method)
Non-recommended cleaning methods
- Needle (internal cleaning)
- Steel wire brushes (external cleaning methods)
- Blow torch (internal/ external cleaning method)
The hardness of the ObXidian coating can cause small particles to detach from the bristles of the brass brush and create dusting over the nozzle. This will give the nozzle a brass-coloured sheen. However, the coating itself is still very much intact, and there will be no compromise to wear performance.
IPA/Acetone may be used to clear clogs, and it will not damage the E3DLC coating.
You can use this nozzle to print different materials. Just make sure to purge the filament thoroughly before starting each print with a new material.